8 Tier Acrylic Square Cupcake Stand Tower Display

Code:SQU8

Be the first to review this product

Availability: In stock

$189.00
OR

Quick Overview

This 8 Tier Square Cupcake Stand Tower can be used as 8 tier or smaller tier. It is specially designed so it can be used as smaller cupcake stand. All tier can be used as top tier or bottom tier.
The entire size: 
Length 19.7" Width 19.7" Height 28.7"
Length 500 * Width 500 * Height 728mm

This stand will hold around 162 cupcakes.

8 Tier Acrylic Square Cupcake Stand Tower Display

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

Product Description

8 Tier Acrylic Square Cupcake Stand Tower Display

The entire size:

Length 19.7" Width 19.7" Height 28.7"
Length 500 * Width 500 * Height 728mm 
Tier1: Dia 150mm, (5.9")
Tier2: Dia 200mm, (7.9")
Tier3: Dia 250mm, (9.8")
Tier4: Dia 300mm, (11.8")
Tier5: Dia 350mm, (13.8")
Tier6: Dia 400mm, (15.7")
Tier7: Dia 450mm, (17.7")
Tier8: Dia 500mm. (19.7")

# 1st,2nd,3rd,4th,5th,6th,7th tier is 4mm (0.16") thick, 8th tier is 5mm (0.2") thick 
# The acrylic comes wrapped in the manufactures protective covering

There is no need for glue or other fixings.
The edges of the acrylic are perfectly clear and polished.
Every part of the stand has been accurately cut and finished
Can be taken apart, washed and stored away for another time.
The stand comes flat packed and only takes a few minutes to assemble.

How many cakes can it hold? Refer to the diagram below for the rough reference

We base our numbers on using a 50mm(2") diameter cupcake for our Square range.

 

ASSEMBLY GUIDE:

Download Assembly instructions for SQUARE cupcake Stand

Parts:
Acrylic discs, head screws, acrylic rods and acrylic feet.

1. Remove the manufacturer’s protective cover from BOTH side of each acrylic component.
2. Take 4 metal head screws and place it on to a flat surface where the stand is to be constructed
3. Now screw the 4 acrylic rods onto the screw thread of the head screw making sure the acrylic disc is clamped firmly between two components.
4. Begin by placing the feet to the underside of the bottom disc ensuring they are evenly spaced.
5. Carefully line up the hole(s) of the largest disk with 4 head screws ensuring the disc is resting securely on the acrylic feet.
6. Continue by placing the next largest disc on to the screw thread of rods and tighten each piece as you go.
7. The final rod is to be used as the supposed for the top tier and the stand is completed by adding the other screw cap into the top.

CARE GUIDE:
The stand is made from acrylic which will scratch if it is not looked after properly.
To clean the product use warm water with a little washing-up liquid and soft cloth.
Do not use any abrasive cleaning products as they will make the acrylic.
Do not put the stand in a dishwasher

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.